Betapack 4
Configuration & Settings
Configuration & settings affect the “Dim” sockets only. The “hot power” sockets will be unaffected by these settings.
The main display consists of four seven-segment displays; the data displayed is dependent on the set-up mode of Betapack 4. Around the outside of these displays are eight red LEDs which indicate the current set-up mode of Betapack 4. An additional green LED is used for DMX indication.
Betapack 4 has a default mode for operation. In this mode none of the set-up mode LEDs will be lit, and the main display will show the DMX address(es).
Mode button
The Mode button is used to cycle through the different set-up modes.
Click the modes to find out more...
Enter button
The Enter button is used to confirm actions.
Up & Down buttons
These are used to adjust the values shown in the main display. Pressing both buttons together will reset the display to the default values.