Hi there,
hope, anyone can help me with this problem:
I use a Leap Frog 96 with actual zerOS 7.9.6
I set up a simple tilt move effect with 4 moving heads, connected to DMX universe1, using DMX out on the desk.
The effect runs very smooth and stable until I do the following:
- change the page of the submasters
- change the page of the MFKs
- change the MFKs section
- do any other change that results in a rewrite of LCDs
the DMX output stucks for a short while, until page setup has finished and LCD write has finished.
I also tested this behaviour with an effect-based shutter chase and a chaser-based Tilt move.
I do not have any problems while changigng pages, if there is no change on LCD. For example change submaster bank without any submaster named or used.
So I came to the conclusion, that writing to the LCDs does disturb continous calculations and/or DMX output for a short while.
After searching in the forum a lot I think, there is no difference between Leap Frog and solution hardware.
So what is my problem?
Actual I can't use the desk for a show, because almost every user action does disturb the output.
I have this problems also with earlier versions of zerOS.
Many Thanks for Your help!
Dirk