Taske

I removed all connections (except supply of course) after roughly 10 minutes (+-2) I switched it off again. (only chasing LED, not even backlight of screen turns on) When I switch it on with a shorter interval it boots more often but not always. Sometimes it boots, sometimes it doesn't. If you agree I would test it with a stabilized 12V PSU to see if this might fix the problem. I sent en eMail to support@zero88.com with a picture of the system information. I also referred the link to the forum kind regards Philip

Hi, I followed your instructions and the console booted successfully. After I loaded the show and restarted it loaded again without any issues. but then, I left the console off for around 3 minutes & It did NOT start. (again LEDs from the left to the right, Screen stays off.) When I restarted the desk again it started. After another immediate restart it didn't boot. Now I am thinking it might have been coincidence that it started with the USB drive plugged in. kind regards Philip

First of I'm sorry for the late reply, Couldn't move out of bed for the last week, I formatted it with the Software, & additional i copied the .exe on the usb drive. kind regards Philip Edit: The desk was without power for over 7 days. When Now it started without any issues. I will do a few more restarts and see if the problem is gone now. Edit2: Desk have shows same behaviour as before. Doesn't boot without the usb drive.

Hi Edward, thanks for the fast answer. I used that tool already - sadly the desk have the same problem. Could it be a hardware problem? Like a corrupted ROM or flash is bad? If I plugin a empty USB pendrive the console won't boot. Kind regards Philip

Hello Zero 88 Team & Members. I have a problem with a FLX S24. The desk is not booting (leds flashing from the left to the right) When I plug in a pendrive with software It boots. I also tried to update (from 7.9.9 to 7.10) which was successful, but it did not solve the problem. When the console is off for more then a few seconds it does not start again, until I put the pendrive and power off/on again. I made a backup of the show before. Even with no show loaded it doesn't boot. (Screen stays off, just leds from left to right) I used the ZerOS-7.10.exe to create the USB and copied the exe file on it as well. I followed the trouble shooting-guide. In case there is a difference, is it possible to make a fresh installation of the OS instead if just updating in? Thank you very much in advance - Philip