Two lanterns are connected to the DMX output.
There are two DMX outputs, so i connected the lanterns, daisy chain, to the unused one using a convertor from the 5 pin output to XLR pin which is what the lanterns have.
The lanterns detect the signal and then i can't get any further.
I have set the addresses on the actual lanterns themselves to A001 and A009.
The lanterns are LFX scan 250.
As i said, i can't seem to get the board to respond!
If there is a training session in the country in the near future, i can make sure i get to it.
Thanks for your reply.