I have a XLS and 2 DateQ 603 Analogue 0-10v Dimmer.
The XLS uses a Din 8 and the Dimmer a 15 pin connector.
The XLS side (picture from the German manual)
The dimmer side:
1-6 = channel 1-6, 7=gnd, 8 = 15 Volt out, 9-15 not used.
Channel 1-6 is clear 1-6 to 1-6.
XLS Pin 8 = 0 V Signal Ground to Dimmer pin 7 = Gnd.
But do I need to connect XLS Pin 7 = Power IN, +20 Volts @ 200mA to Dimmer pin 8 = 15 Volt out ?
Why power IN and Out and how about the 5 volt difference and what about the 200mA?
And 20 volt, 15 volt... where are the 10 volt from 0-10 volt...?