Jump to content
Vari-Lite Controls Support Forum

Recommended Posts

Posted

I have a Betapack 2, analogue only version, which is not working properly.

 

When plugged in, without a desk or analogue cable, the dimmers sit at preheat level, the channel test buttons bring up the channels as expected.

 

When I plug the desk in (both a zero 88 level6 and a Pulsar 6 way desk, re-wired zero 88) all channels come up to full (or close to full).

 

Pulling the lead out returns the channels to zero.

 

The contol voltage is set to positive. Putting a 9v battery between ground and the channel 1/2/3/4/5/6 control lines (with a bit of wire in the DIN socket) brings the channels up individually.

 

I've run out of ideas on what to test next, one last step would be to swap the control boards with another unit.

 

The unit is a few years old and until recently has been working fine.

 

Any idea

 

Dave

  • 2 weeks later...
Posted

hi Dave,

 

think that I spoke to you about this already but if not please contact me on keith.rogers@cooperindustries.com

or give me a call on my direct dial 01633 833 101.

Regards,

Keith Rogers

Zero 88 Support: support@zero88.com

Please sign in to comment

You will be able to leave a comment after signing in



Sign In Now
×
×
  • Create New...

Important Information

We have placed cookies on your device to help make this website better. You can adjust your cookie settings, otherwise we'll assume you're okay to continue.