Stopping Movers after a cue with an effect running

[Worcester RGSTech]

If I record a cue running an effect in which movers are moving on a preset pattern, figure of 8 for example, does anyone know if there is a way of stopping them moving whilst blacked out in the next cue? I have tried multiple ways and the only successful method seems to be to record them in a position at a very low intensity when stopping the effect. I don't want them moving around whilst blacked out, especially as their subsequent cue will likely be in a static position as a special.

I don't doubt that not so many months ago Edward or Jon would have been on with a solution. Alas we seem to have been hung out to dry these days.

[kgallen]

Hi @Worcester RGSTech
 

This is a common gotcha on ZerOS consoles. 

I don’t know the exact syntax on Solution, sorry, but assuming you have a fairly recent ZerOS then you need to Update the cue with Effect Off with SmartTag turned off. 
 

1. Select the fixtures of interest

2. [No Effect]

3. [Update]

4. Turn off SmartTag

5. Tap the Playback button holding that cue

 

Almost certainly the blackout cue was recorded with SmartTag on in which case it doesn’t record the Effect Off instruction, just the fixtures going to intensity 0. This means your fixtures keep dancing when they are dark. 

Yep Jon and Edward are gone but there are user-folk on here who can still help you. 

[Worcester RGSTech]

Hi @kgallen

Thank you, I'll give this a try. I'm running ZerOS 7.14.... the most recent version.

I'm not sure that the Solution has SmartTag or whether it uses another name, but I imagine that it will be reasonably obvious.

 

Thank you.

Simon

[kgallen]

To clarify, for Update you need to get up the options box to turn off SmartTag. For FLX this is press and hold the Update key. 

[kgallen]

ETA if my instructions are not clear, Edward documented the process in this paragraph (although again for FLX series). As he says, you might need to Track Forward, depending on where your cue is programmed/when you do the Update process:

Quote

When SmartTag is enabled, attribute data will not be stored for fixtures @ 0% when recording/updating. Effect information is attribute data, and so if you apply [No Effect] for fixtures that are currently @ 0%, you will need to disable SmartTag in order to ensure your No Effect instruction is included.

If you wish to update a cue to stop the effect running on fixtures that are @ 0%, select the fixtures and tap [No Effect], tap UPDATE, and in the Update Options you'll need to ensure SmartTag is disabled, and Track Forwards is enabled. This will send your [No Effect] instruction down the cue stack, up until the next cue that includes effect information for these fixtures. If you just do a Cue Only update, the [No Effect] instruction will only be added to the cue you are updating, meaning the fixtures will resume running their effect in the very next cue.

 

[Worcester RGSTech]

@kgallen

I tried following your instructions, but so far with no success.

The Solution does not appear to show 'SmartTag' in the options box, just 'Clear Tagging' It seems to make no difference whether I click the 'Effects Pallete 1 No Effect' box. Cue Only should make no difference in that in the first instance I just want to stop the effect in 1 Cue. ( the desk is currently running in Cue Only mode although that may change)Does SmartTag only appear when using Tracking ?

IMG_0550.HEIC