Determining Channel Mode of a Patched Fixture

[DALX]

Can you determine  what channel mode a fixture is patched at ? It is easy to determine if there are several patched by looking at the Address in Fixture Schedule, but it is not obvious if it is the last fixture, unless I patch something after it to see the Addresses.

[Edward Z88]

Hi @DALX

12 minutes ago, DALX said:

Can you determine  what channel mode a fixture is patched at ?

In the Fixture Schedule, tap on the fixture in the "Change All Fixtures / Modes" column. The current mode will then be highlighted. Click Cancel to close.

Hope this helps.

[DALX]

Thank you Edward, it certainly does help. I tried searching for this but did not find a direct answer, so I have a word document to keep track of these useful snippets.

[Edward Z88]

46 minutes ago, DALX said:

Thank you Edward, it certainly does help. I tried searching for this but did not find a direct answer, so I have a word document to keep track of these useful snippets.

I've added this tip here...

https://www.zero88.com/manuals/zeros/patching/fixture-schedule

[DALX]

Very useful thank you Edward.